Ford Barra 1000HP Engine kit

Spool Ford Barra XR6 Turbo 1000FWHP Rebuild Kit

This Rebuild Kit includes the following quality parts:

• Spool Forged H Beam Conrods
• CP Bullet Or Ross Racing Forged Pistons with 4 x Valve Reliefs (Rings, Pins and Locks Included)
• Cometic MLS Head Gasket, or Athena Cut Ring Head gasket
• ACL Race Series Main Bearings (360 thrust)  
• ACL Race Series Big End Bearings 

CP Bullet Pistons feature:

• 2618 Forged Alloy
• Offset Gudgeon Pin
• 4 x Valve Pockets
• 0.200” 51 pins STD
• Includes piston rings, pins and pin locks.

Ross Racing Pistons Feature:

• Bore Size: +0.001" or +0.25mm
• Pistons come with NPR Gas Nitrided top ring, three pcs. oil
• 4 Valve Pockets
• 0.225” wall Carbon steel
• Forged 2618
• Locks

Spool Connecting Rods Feature:

• ARP 2000 fasteners 
• High tensile 4340 forged steel
• 2 Piece forging
• Hardness of HRC36-42
• Dowelled caps for precision alignment
• X-RAY & Sonic tested
• Quenching and heat treated
• Shot peened
• 100% Magnafluxed
• Weight Matched Sets +/- 1 gram
• Vacuum degassed to remove impurities

Please Note:

*STD bore size pistons are not recommended in a used bore for any performance engine unless the bores have done minimal work with minimal wear and the correct piston to bore clearance can be adhered to.

All piston manufacturers have a specific piston to bore clearance that they recommend. If STD bore pistons are requested and there is a piston to bore clearance issue we will not exchange or refund, due to the reasons given above.