HALTECH GPS Speed Input Module Length: 300mm (HT-011310)

It generates a precise 0V to 12V pulsed digital speed signal using GPS data. This allows your ECU to receive accurate speed information for functions such as data logging, traction control strategies, and general speed-based calculations.

It is designed for Haltech ECUs and any setup that accepts a digital speed input via SPI or DPI inputs. It can also work with other aftermarket ECUs that accept a 5000 PPK digital speed signal.

The module provides high accuracy within a 0.3 percent deviation, supported by Anti-GPS Drift and Pulse Compensation technologies for stable readings in tunnels or low-signal areas.

The module updates at 10Hz, providing fast and consistent speed data suitable for performance and motorsport applications.

The module uses a fixed calibration of 5000 pulses per kilometre (5000 PPK).

Yes. It includes the GPS Speed Input Module (300mm), GPS antenna, and the matching male DTM-3 connector with pins

In many cases it can, especially for speed signal requirements where extreme precision at very low speeds is not essential. It is ideal for ECUs that need a reliable and easy-to-install digital speed input.

Yes. The module features Pulse Compensation and Anti-GPS Drift technology to maintain stable output in tunnels and low-signal environments.

The 300mm length refers to the module's harness length.

It is intended for ECU speed inputs rather than as a direct speedometer correction device. However, ECUs that output corrected speed data may allow you to use it downstream if your setup supports it